<progress id="xqhub"><legend id="xqhub"></legend></progress>

  1. <div id="xqhub"></div>

    <progress id="xqhub"><tbody id="xqhub"></tbody></progress>
    <li id="xqhub"></li>
  2. <li id="xqhub"></li>

    <th id="xqhub"></th>

  3. <button id="xqhub"></button>
    <button id="xqhub"></button>
    <dl id="xqhub"><s id="xqhub"></s></dl>
    <div id="xqhub"><span id="xqhub"></span></div>
  4. <td id="xqhub"></td>

    light tester system

    日期:2022-01-14 03:35
    瀏覽次數:2837
    摘要:
                light tester system
    (8)Standards  
      Watt Wr fr  
      11W 10.8±1.3 W 56.1±4 KHz  
      14W 13.5±1.4 W 56.9±4 KHz  
      19W 18.9±2.2 W 53.5±4 KHz  
      22W 17.6±2.0 W 46.6±4 KHz  
       
    Inspection Method:  
       
    1.Connect Check wire(CH3,CH4/CH5,CH6) to pin (P3,P4/P5,P6) connected. [Load Resistor: 600 ohm]
       ( 300ohm resistor*2 [300Ω30W Cement resistor] series connection. )  
       
    2.Connect Check wire(CH1,CH2)with power source of AC220V/50Hz to Lands or Wire (F1,P2).   
       
    3.Measure DATA (Wr/fr) after 2 seconds from turn on.  
       
    4.Turn off AC220V/50Hz, then Switch off the Load Resistor.   
       
       
    <<Caution>>  
    (1) You should not to pull strongly when Wr/fr is measured.  
       
    (2)Since a measuring method is different compared with other types, Pls Be careful.

     

    test volt, WR,FR

    粵公網安備 44030602001522號

    {首页主词标题}

    <progress id="xqhub"><legend id="xqhub"></legend></progress>

    1. <div id="xqhub"></div>

      <progress id="xqhub"><tbody id="xqhub"></tbody></progress>
      <li id="xqhub"></li>
    2. <li id="xqhub"></li>

      <th id="xqhub"></th>

    3. <button id="xqhub"></button>
      <button id="xqhub"></button>
      <dl id="xqhub"><s id="xqhub"></s></dl>
      <div id="xqhub"><span id="xqhub"></span></div>
    4. <td id="xqhub"></td>